Walls Stay Dry
Fixed gutters and eave trim stop the overflow that runs down inside the wall panels.


As a Peru commercial roof repair contractor, we fix metal shops and light industrial roofs at the eaves, gutters, laps, and fastener rows.
Peru commercial roof repair on metal buildings centers on the low edge, where snow and meltwater sit longest each winter.
The bottom few feet of each panel stay wet the longest. Rust starts there, washers at the eave screws dry out, and gutters overflow back against the wall line.
We start every Peru metal roof at the eave, then work uphill through the laps and screw rows to the ridge.

Metal buildings show their leaks from both sides of the wall.
Gutter overflow and failed eave trim send water behind the wall panels.
Rust at the low edge spreads into the laps if the panel stays in place.
Raised screw heads have backed out with temperature swings and let water down the shank.
Ice in the gutter dams meltwater against the eave panels and laps.
Water landing on machines or stored goods needs a call now and a cover below.
Repairs at the eave protect the whole wall line.
Fixed gutters and eave trim stop the overflow that runs down inside the wall panels.
Swapping rusted eave panels removes soft steel before it eats into the next lap.
New oversized screws with fresh washers close the holes that loosened over the years.
Clear gutters and sealed laps let meltwater leave the roof instead of backing up.
Fixes for the parts of a metal roof that wear first.
Rusted lower panels are replaced with matching profile and gauge, lapped under the sheet above.
Rusted gutter sections are replaced and downspouts cleared so water leaves the eave.
Worn screws come out and oversized screws with new washers go in.
End and side laps get cleaned, new stitch screws, and butyl or seam tape.
Call and tell us which wall. The gutter and eave panels on that side are the first things we check.
(463) 466-9764Call UsMetal roof visits start low and work uphill.
Gutters, trim, and the lowest panels get checked first, where water and snow stay longest.
Each screw row and lap is checked on the way to the ridge, with problems marked in paint.
Rusted panels are swapped, screws replaced, and laps sealed.
Water is run through the repaired gutters to confirm they drain to the downspouts.
Peru is one of five towns we cover from Kokomo. Call us or send us a message if your building is outside them.
Home base for flat, metal, and plant roof repairs.
Leaks traced from office and store ceilings to the roof.
Ponding, drains, and sagging spots on flat roofs.
Downtown blocks with parapets and internal gutters.
Storm and hail checks with a dated photo record.
What Peru shop and plant owners ask about metal roof repairs.
It turns on the number of screws and laps involved, how many panels need swapping, gutter work, and roof height. A free estimate after the inspection sets the price.
Call the number on this page. We cover Peru from our Kokomo base and inspect metal roofs starting at the eave.
Yes. Gutter and downspout repairs are often part of the same visit, since overflow causes many wall-line leaks.
Snow and meltwater sit longest at the low edge, so those panels stay wet more days each year.
Screws with cracked washers get replaced. Sealant over a bad washer wears out fast.
Yes. Cracked skylight panels are replaced to match the roof profile and sealed at the laps.
Tell us where water shows up in your metal building. We will start at the eave and work up.